REPL manufacture on the of the largest ranges of moulded polymeric heat shrinkable components, from cable end sealing caps, cable breakout boots for sealing multi-core cables in terminations and other specialist products. Where applicable, these are supplied with hot melt adhesive linings to ensure a watertight seal between the cable and moulding.
In addition, we also manufacture a range of elastomeric cold shrink end caps and cable breakouts for use where installation without heat sources are preferred.
Heat Shrink Cable/Pipe End Caps
EC = Heat Shrink Cable End Caps with Adhesive
ECC = Heat Shrink Conductive Cable End Caps
ECV = Heat Shrink Cable End Caps with built in Valve for Pressurised Cables
ECIP = Heat Shrink End Caps for Pre- insulated Pipes
Heat Shrink Cable Breakouts for Low Voltage Cables
EB2 = Heat Shrink Cable Breakouts for 2-core Cables
EB3 = Heat Shrink Cable Breakouts for 3-core Cables
EB4 = Heat Shrink Cable Breakouts for 4-core Cables
EB5 = Heat Shrink Cable Breakouts for 5-core Cables
EB6 = Heat Shrink Cable Breakouts for 6-core Cables
Heat Shrink Busbar Junction Insulating Shrouds
RBJS = Heat Shrink Moulded Shrouds for Busbar Sections